GET STUCK SPA REPAIR KIT

Repair Spa Shells, Jets, Plumbing when Wet, Dry or even Underwater!

PREPARATION: 1. Clean bond area with Denatured Alcohol Swipe, roughen with 60 grit sandpaper, clean again with Swipe. 2. Remove cap by twisting counter-clockwise until tabs clear slots, then pull vertically off. 3. Affix static mixing tip to syringe by aligning the flanged end with the slot, depress tip into slot, turn clockwise to lock. 4. Immerse syringe and tip in 110˚F water for 3 minutes to soften glue. 5. Insert syringe with mixing tip into dispensing gun. 6. Squeeze the trigger of the dispensing gun to force glue to mix as it passes through the mixing tip. 7. Discard the first 3" of glue from the tip as it may not be mixed properly due to lack of initial back-pressure. 8. Apply glue to both surfaces to be bonded, press joint together leaving some glue in the joint. 5. At 70˙F the working time=30 Min, Handling strength=4 Hrs, Full Cure=24 Hrs. 6. To remove uncured glue let it cure until just after it is no longer liquid, then cut and strip off. Once glue is fully cured it is very difficult to remove.  Warmer temperatures shorten cure time, lower temps lengthen cure time. Leave tip on syringe to act as a cap as glue cures within it.

Spa Shell or Jet Crack Repair: Cut a piece of UltraWax Relief Sheet 2” longer and 2” wider than the crack. Apply mixed glue to the center of the sheet. Place the sheet over the crack. Apply pressure from the non-glue side of the sheetr to force glue into crack or to feather the glue around it. Remove UltraWax Relief Sheet after the glue is cured.
 
Spa Pipe or Cracked Fitting Repair: Turn off pressure in pipe. Cut one of the supplied patches to the proper size to fit around a leaking pipe. Clean the patch with a Denatured Alcohol Swipe, roughen with 60 grit sandpaper and clean with Swipe again. Apply glue to the patch and pipe, wrap patch around pipe. Hold patch in place with duct tape (not supplied). Remove tape after curing.

Spa Fitting Seepage Repair: Turn off pressure in fitting. Clean the end of fitting with Denatured Alcohol Swipe. Cut a piece of UltraWax Relief Sheet to fit around the leaking fitting. Apply glue to the center of the sheet. Wrap the sheet around the fitting, forming a bead of glue around the fitting end. After the glue cures, remove sheet and restore pressure to the line.

Includes: 57gr Underwater Glue (1), Denatured Alcohol Swipes (3) Mixing Cups (3), Mixing Sticks (3), 4” x 4”  Reinforced Vinyl Patches (3), UltraWax 12” x 12” Release Sheets (3), 60 grit sandpaper (3), Instructions (1)

*Dispensing Gun or Caulking Gun Adapter Required*